Measurement & Instrumentation (M&I) Technician I/II/III/IV

The role

The M&I Technician performs routine work relating to commissioning, measurement, I&E, and support of gathering/processing communication systems. This includes assisting in the construction, maintenance, repair and calibration of measurement equipment.

What you will do

• Provide field support of instrumentation, controls, communications network, and electrical equipment
• Provide technical support to Measurement/M&I technicians for SCADA data export
• Execute field-based system tasks on host SCADA systems and configure/commission new equipment
• Build RTU, radio, and device configurations for newly installed facilities
• Monitor and manage overall health of SCADA system
• Direct communication with vendors and service companies
• Install, configure, test, calibrate, operate, troubleshoot, maintain and inspect transmitters, pressure and level controllers
• Troubleshoot and repair analyzers, AC motor starters, VFD’s, control circuits, and PLC operations
• Install and maintain electrical, electronic and pneumatic components on compressor units, generator control panels, pump units, ignition systems and air fuel ration systems
• Identify and analyze failures and perform Root Cause Failure analysis

Required qualifications

• High School Diploma or GED
• 2+ years of applicable I&E/M&I, measurement, communications, and operations experience
• Extensive knowledge of preventative, predictive and corrective maintenance
• Advanced knowledge of PLC troubleshooting skills (Allen Bradley Control Logix, PLC5 & SLC500)
• Instrumentation calibration, repair and troubleshooting on pressure, level, flow and temperature devices
• Advanced computer skills and knowledge of measurement specific applications and software programs
• Extensive working knowledge of SCADA and Communications systems
• Ability to pass a physical capabilities test including lifting and carrying 60 lbs. and walking 1/2 mile at various inclines
• Analytical thinking, troubleshooting, and logical testing skills
• Valid driver’s license

Nice to have

• associate’s degree in electronics or engineering

Before you apply

• Must be at least 21 years of age at date of hire
• Ability to pass a physical capabilities test
• Role is covered under PHMSA / FMCSA regulations

About the company

EQT Corporation values collaboration through Transparent Leadership, Connected Impact, and Supported Growth.